That is done in the SYSTEM > TRAINER function. 2.2. In the same TRAINER function on the Master transmitter you MUST go to page 4/4 and change ACT from INH to OFF, then select the desired switch. Note that ACT will not change from OFF until you connect the Slave transmitter AND engage the switch you selected.
Operation: Turn on your transmitter first, then turn on your receiver. Set your aircraft down on a flat surface and have it remain level (the flight controller LED will flash rapidly). When the gyro is properly calibrated, the aileron servos will cycle 3 times in rapid succession; then the elevator will
1) Set the LIMIT on the 401 so that you do not hear any binding when moving the rudder full left and right. Binding = servo making a straining / buzzing noise. 2) At this stage you will probably be getting full throw one way on the slider but not the other - we need to CENTER the slider relative to the servo.
FUTABA-RC. 07-28-2021 07:15 AM. Look at page 136 of the 16SZ manual. Must be in 2AIL wing type. If you need to change that, note all your other settings since changing wing type wipes it all out. Use a 3 position switch. up=normal aileron. middle = take off flaps. down= landing flaps.
.
